01-28-2008 09:11 PM - edited 03-05-2019 08:46 PM
Hi,
We wanted to configure the network attached.
We wanted to know how best we can configure access layer switches, distribution switches & Core switches.
Access switch is 3750 PoE,distribution is 4506 & Core is 6513
We are planning to use static routing within the campus & OSPF across WAN.
If you have any configuration examples it would have been very helpful.
Thanks.
Rgds.,
Sack
01-28-2008 09:54 PM
Sachin,
Have a look at the "Cisco Validated Design" from the below URL for detail drawings and configuration information on Campus, Data Center, etc, designs. This should assist you in coming up with an optimal design.
http://www.cisco.com/en/US/netsol/ns741/networking_solutions_program_home.html
Regards,
Arul
** Please rate all helpful posts **
01-29-2008 05:17 AM
Arul's suggestion is right on. To add I suggest looking at the High Availability Campus Network Design-Routed Access Layer using EIGRP or OSPF. I've always thouhgt this design provides the quickest convergence, fault-tolerance, and most efficient load-sharing for a campus network.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide