11-21-2017 08:58 AM - edited 03-08-2019 12:49 PM
Need to reset to factory default-how is that done in the C9300-48T-E switch.
Solved! Go to Solution.
11-21-2017 04:34 PM
there is two options:
First option :
Step 1 Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds.
Step 2 Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch restarts.
Second option :
C9300#write erase
Erasing the nvram filesystem will remove all configuration files! Continue? [confirm] yes
Thanks
11-21-2017 04:34 PM
there is two options:
First option :
Step 1 Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds.
Step 2 Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch restarts.
Second option :
C9300#write erase
Erasing the nvram filesystem will remove all configuration files! Continue? [confirm] yes
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide