03-24-2013 08:30 PM - edited 03-07-2019 12:27 PM
I would like to hang a HP wireless access point off port fa0/1/8 and deliver PoE to it.
The A/P is to be assigned 192.168.100.252.
Currently fa0/0 has the ip address 192.168.100.251/24.
Ports fa0/1/0 to fa0/1/7 are in voice vlan 100.
Appropriate section of the config below:
interface Loopback0
description $FW_INSIDE$
ip address 10.1.10.2 255.255.255.252
ip virtual-reassembly
!
interface FastEthernet0/0
description $FW_OUTSIDE$
ip address 192.168.100.251 255.255.255.0
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
crypto map IPSEC-TRAFFIC
!
interface Integrated-Service-Engine0/0
ip unnumbered Loopback0
ip nat inside
ip virtual-reassembly
service-module ip address 10.1.10.1 255.255.255.252
service-module ip default-gateway 10.1.10.2
!
interface FastEthernet0/1/0
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/1
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/2
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/3
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/4
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/5
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/6
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/7
switchport voice vlan 100
macro description cisco-phone
!
interface FastEthernet0/1/8
switchport mode trunk
macro description HP-access-point
!
interface Vlan1
description $FW_INSIDE$
ip address 192.168.10.1 255.255.255.0
ip nat inside
ip virtual-reassembly
!
interface Vlan100
description $FW_INSIDE$
ip address 10.1.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly
!
Thanks,
Brendon.
03-24-2013 10:46 PM
Only phones uses voice vlan. AP and anything will be in default vlan 1.
10-01-2014 12:59 PM
where do you find the physical port on the uc520 correlating to fa0/1/8? I see 8 ports, 0 - 7.
Thanks.
10-03-2014 03:18 PM
I found it. It's the expansion port to the right of the WAN port.
Thanks.
Dave
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: