Hi All,
I have enabled UDLD on some LAG members that run over fibre, see config below.
int eth1/1
udld port aggressive
udld fast-hello 300
errdisable recovery cause udld
errdisable recovery interval 30
with the hello's set at 300ms i was hoping to get a timeout of 900ms so 3 x the hello. Is this achievable? at the moment it is set to 5000ms which is 5 seconds - so based on this it won't detect a failure condition until the 5 seconds is up?
Interface Te1/1/10
---
Port enable administrative configuration setting: Enabled / in aggressive mode
Port enable operational state: Enabled / in aggressive mode
Current bidirectional state: Bidirectional
Current operational state: Advertisement - Single neighbor detected
Message interval: 300 ms
Time out interval: 5000 ms
any help is greatly appreciated.
Thanks
