Unable to add SG300-28SFP to CNA Comunity!

[sebastiaan.makkinje]

Hi.

In Cisco Network Assistant, I am unable to add my SG300-28SFP to my existing Community.

At first it was just recognized as an "unknown device". Then i installed latest version 6.1 of CNA and now CNA finds the SG300, but just as an neighbor unit. I can not add it to the community!

I have the latest firmware installed in the SG300, and all the whitepapers says that CNA does support SG300 family switches.

My existing CNA community has around 45 switches, mostly 2950/2960/3500 cisco switches, that are supervised.

Have i missed some setting in the SG300 that prevents the CNA from fully connect to the SG300?

// Sebastiaan

[sebastiaan.makkinje]

Ok. I created a new Community in CNA and scanned my network for devices.

Now the SG300 is discovered and added as a member in the new community. Strange.

But, now I got a new problem instead. Now all my Catalyst 3508G XL units can´t be added as members in this Community. The 3508G is an 8 port fiber module switch that I use as connection hubs in my network. Is this an Issue between CNA 6.1 and 3508G devices?