cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

207
Views
0
Helpful
2
Replies
Beginner

Understanding conformed errors

Hello,

Could anybody help me to understand conformed errors in the command show policy-map?.

 

Thanks in advance.

 

 

 

2 REPLIES 2
Cisco Employee

Sorry I dont see any errors??

Sorry I dont see any errors?????

Cisco Employee

Hey,Check the example:The two

Hey,

Check the example:

The two-rate policer marks 500 kbps of traffic as conforming, 500 kbps of traffic as exceeding, and 250 kbps of traffic as violating the specified rate. Packets marked as conforming to the rate will be sent as is, and packets marked as exceeding the rate will be marked with IP Precedence 2 and then sent. Packets marked as violating the rate are dropped.

Router# show policy-map interface serial3/0

 Serial3/0

  Service-policy output: policy1
   Class-map: police (match all)

   148803 packets, 36605538 bytes

    30 second offered rate 1249000 bps, drop rate 249000 bps

    Match: access-group 101

    police:

     cir 500000 bps, conform-burst 10000, pir 1000000, peak-burst 100000

     conformed 59538 packets, 14646348 bytes; action: transmit

     exceeded 59538 packets, 14646348 bytes; action: set-prec-transmit 2

     violated 29731 packets, 7313826 bytes; action: drop

     conformed 499000 bps, exceed 500000 bps violate 249000 bps


   Class-map: class-default (match-any)

    19 packets, 1990 bytes

    30 seconds offered rate 0 bps, drop rate 0 bps

    Match: any


HTH.

Regards,

RS.

CreatePlease to create content
Content for Community-Ad