Switching

I am attempting to configure eigrp between a Cisco 5510 and a Cisco 3560. Here is the relevant configuration: ASA: interface Ethernet0/1 nameif Inside security-level 100 ip address 172.17.254.1 255.255.255.0 router eigrp 2 network 172.17.254...

HI, Have a simple doubt, Will cisco switch send gratuitous arp if HSRP not enabled ???? in which conditions a cisco switch\router\firewall send gratuitous ARP ???

So I am requesting help from the Cisco community on this issue as the cable company states there equipment is working fine.  At all my facilities I have a guest Internet service setup through a local Internet provide to provide Internet services to t...

Hi, I have two VSS (6509) running in different location, actually two sites they merge. so some of the servers moved from site B to site A but the default gateway is in site A. unfortunately the servers moved they cannot communicate to the default ga...

Hi,does someone know how to configure "logging persistent" on Catalyst 2960-S switches?I did it sucessfully on ISR G2 routers under IOS 15x, but on the Catalyst 2960S it seems to be not working,although the command "logging" has the option "persisten...

Hi,please help me.I have two HP 2610 with following configuration.; J9085A Configuration Editor; Created on release #R.11.25hostname "Switch B"snmp-server contact "Infa Systems Ltd"snmp-server location "HKC"time timezone 8interface 25   flow-controle...

We have a Netapp storage device and we are having intermittent problems with it. When I look at the ARP cache on our core switch I found that the storage guys have assigned multiple IP addresses to the same MAC. Is this possible Internet  172.16.14.2...

We have a netapp storage device and we are having intermittent problems with it. When I look at the ARP cache on our core switch I noticed that the storage guys have created mulitple shares with the different IP address but they all point to the same...

Hi AllI hope you can help. We have an AS with 3 routers with 2 or 3 BGP peers on each router.I'm planning to change the Local Preference on one of the BGP peers so that all of the possible traffic is sent via that peer (it is partial transit so not a...

 I want to know why there is  Dedicated supervisor engine slot numbers in core switch.    FeatureCisco Catalyst WS-C4503-E ChassisCisco Catalyst WS-C4506-E ChassisCisco Catalyst WS-C4507R+E ChassisCisco Catalyst WS-C4510R+E ChassisDedicated superviso...

I have two routers that have two seperate t1's.  Both routers connect to a MPLS network that talks back to the corporate office.  I have HSRP setup on both routers.  The routers are connected across the LAN and HSRP works fine.  I am only announcing ...