cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
317
Views
5
Helpful
2
Replies

unknow protocol drops

skelley5000
Level 1
Level 1

I am seeing this on one my uplinks on a 3850 I currently have up and running.

 

This is a layer 2 connection that is trunked with a 3750, both ports on each switch are configured for the correct VLAN's but one thing I did notice is the uplink on the 3750 has the following where the 3850 does not..

 

3750 uplink port

interface GigabitEthernet2/1/4
 description
 switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 3,6,10
 switchport mode trunk
 priority-queue out
 mls qos trust dscp

 

3850

interface TenGigabitEthernet1/1/3
 description
 switchport trunk allowed vlan 3,6,10
 switchport mode trunk

 

Would this cause the protocol drops?

2 Replies 2

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Those statements shouldn't have anything to do with protocol drops.

More likely, one switch is transmitting a "special" protocol (e.g. VTP, DTP, etc.) that the other switch doesn't recognize.

I second Joseph's statement.  I have seen this numerously with Cisco to "non-cisco" devices with the "non-cisco" device running LLDP, though it could be another protocol.

To check for LLDP (http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/system_management/configuration/guide/sm_nx_os_cg/sm_lldp.html).  It needs to be turned on both for transmitting (globally or on the interface) and for receiving.

Regards,

Kevin

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: