Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently setting up 9800 WLC; everything has been going fine, but until I got to the mobility part, and now I have an issue. 1. 1st issue, the Mobility MAC address is all zeros, it should be the MAC of the Mgmt IP (picture added)2. 2nd issue, ...
I am seeing this on one my uplinks on a 3850 I currently have up and running. This is a layer 2 connection that is trunked with a 3750, both ports on each switch are configured for the correct VLAN's but one thing I did notice is the uplink on the 37...
I have 4 radius servers setup on my switchMy question is I believe if there is no response from the first radius server it will try the second and so on, but what if the authentication is rejected will the switch still try the next radius server?
I am adding my Cisco 3750's into prime and I would like to enable NMSP fro each switch using prime.So far I have only found the way to do this is by editing each switch once Prime has synchronizing with the switch. Is there away to do this in bulk? I...
I upgraded my controller and pre-downloaded the image to all of the AP's for a later reboot. When I try to reboot the controller I get the following message.AP software being upgraded, please try again later All AP's show the image has been pre-down...
yes I can set the Mobility MAC address, but when I go to the peer configuration, the WLC I am currently in, is not showing up.. This WLC should be listed, along with its IP and SCC Hash, this should be there by default.. I can't set up mobility betw...
I set up Discovery with all of the different sites, input the correct user name and pw for telnet for all of the devices. Majority of the devices work fine but under device work center I see a lot of device with the wrong CLI credential error. When I...
I would like to move an AIR-LAP1142N-A-K9 which it is running IOS 12.4(23c)JA2 from an older 2500 WLC (7.0.116.0) to our 5508 WLC (7.4.121.0). I was reading the compatibility list and the AP is compatible but with IOS 15.2(2)JB3. When I move the AP ...
That all depends on the version of code that is running on the controller, I started off with HREAP on our 5508 because I was running a 7.0.x.x version once I moved to 7.4 HREAP was converted to flex connect...
