Upgrade SG350X MIB and Firmware

[laurathaqi]

Dear community, 

I want to upgrade my switch, and in the Cisco official site, I found two files, the Firmware .bin one and the MIB folder which contains lots of file on it. 

From the readings I understood that MIB is the boot code. However, I am unsure how to upgrade the boot code as the MIB folder contains lots of file inside. 

Can someone point me to a resource were both firmware and boot code are upgraded in Cisco SG350X. 

Looking forward to hearing from you. 

Best regards,

Laura 

[balaji.bandi · Accepted solution]

example always .bin file :

image_tesla_hybrid_2.5.8.15_release_cisco_signed.bin

https://www.youtube.com/watch?v=U3VSsSOWMzo

[laurathaqi]

Hi @balaji.bandi 

yes that is correct for the .bin file for the firmware. But not for the Boot code! The video shows .ros and .rfp files for boot code. However, the package I downloaded from the Cisco site, does not contain any kind of file with these extensions. 

Thank you,

Laura 

[balaji.bandi]

if the boot required to upgrade, if not required you can use .bin to upgrade.