URGENT! 1600 Setup..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-18-2005 09:37 PM - edited 03-05-2019 11:41 AM
Our ISP turned up our T1 today. For whatever reason I told them that I would provide the router and configure it myself. Now that I have been staring at this all day I realize I have no clue where to start. Here is what I have: (IPs have been changed for security)
Qwest serial = 10.100.100.57/30
my serial = 10.100.100.58/30
usable IP block: 10.10.10.224/29
eth0: 10.10.10.225
dns = 205.171.3.65
eth 1private lan = 192.168.1.254/24
I configured Serial0 with 10.100.100.58 and setup NAT to my private LAN and that all worked great. But what I am needing to do is place 2 pieces of hardware on the public LAN using the 10.10.10.xxx address assigned to me. I cannot get these machines to do anything on ther Internet. I have bridged the ser0 and eth0, I have tried routing, i have sat and stared. I'm at a loss. Any help will be appreciated.
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-23-2005 04:40 AM
hello
don't know whether you've solved it by now, but shouldn't your public ip addresses be in the same network range as as your serial ip address?
regards,
michael
