Switching

When would I router running eigrp for example need to make a query, I thought if id didnt know about a route it would drop the packet unless a default is used ?

Hi,I've configured a reverse telnet, how can i remove speed in the aux configuration? when i use no speed, i've got the message "failed to change".

Hi all, I have always wondered how this is acheived, Is it via satelites, or some cables under the sea etc ?

hi, i'm noob here.Just have a question for all experts.what is the meaning of this -> 10.150.10.5/32 ??The "/" means what?

I am planning to start a small WISP and I am just running through what I will need as far as a router and switches. I have attached a network diagram which contains a 2851 router with 9 port 10/100 HWIC and the switches are Catalyst Express 500 serie...

hi all,just curious if there is a best practice for the naming of the inside int on a pix device. is there any harm in having it be addressed with an address from the vlan management pool?thanks,R

Hi all,Where can I find some info on available SFP modules from cisco and what platforms they will work in ???thanks,George

Hello guys,I have recently encountered a subneting question which I need some explanation for. The question says:You are attempting to properly subnet the IP space of one of the Testking location.For the network “200.x.x.0” there is a need for 3 loop...

I have found that connecting a PC to a n IP Phone through a Hub causes the PC to be very slow connecting to anything on the network and often goes off line. Without the Hub it is fine. Also without the IP phone the Hub works fine. What would cause th...

we are planning to migrate our exsting data centre from a traditional hub / switch network to enterprised based Cisco Switches.At the core layer we have planned with Cisco 6500 E, with CSM, Firewall blade and NAM modules, along with 2 X 48 port 10/10...

Hello all,I am trying to setup an Cisco PIX 515E.Outside interface is connected to internet.Inside interface is connected to inside private LAN.I am able to use http traffic from inside LAN. However, I have problem with DNS and Ping.I can not ping in...

I have 2 separate exchange servers for 2 separate exchange organizations on the same private network. -One has an ip of 192.168.0.2 -Two has an ip of 192.168.0.3 The network is protected by a 1811 router/firewall and each server has their own public ...

Hope someone can help me a bit. I know very little about routers, and what I do know does not seem to apply to my new job.Our current hardware is a 1760 router with a WIC-T1 CSU and a WIC-4ESW (which is not being used). We also have the Firewall fe...