04-25-2016 03:01 PM - edited 03-08-2019 05:29 AM
Hi Everyone,
We have 2811 configured with PIM.
interface FastEthernet0/0
description outside
ip address 10.225.30.50 255.255.255.0
ip pim sparse-mode
ip nat outside
ip virtual-reassembly
zone-member security out-zone
duplex auto
speed auto
!
interface FastEthernet0/1
description inside
ip address 140.x.x.x 255.255.255.0
ip pim sparse-mode
ip nat inside
ip virtual-reassembly
zone-member security in-zone
duplex auto
speed auto
ip nat inside source list 101 interface FastEthernet0/0 overload
router#show ip nat translations
router#
Need to confirm is this router performing any NAT translations or not?
Regards
Mahesh
!
Solved! Go to Solution.
04-25-2016 06:57 PM
Hi Mahesh,
Have you configured an access list for the Internal subnet (access list 101)?
access-list 101 permit ip 140.x.x.x 0.0.0.255 any
Thanks,
Reza
04-25-2016 06:57 PM
Hi Mahesh,
Have you configured an access list for the Internal subnet (access list 101)?
access-list 101 permit ip 140.x.x.x 0.0.0.255 any
Thanks,
Reza
04-25-2016 08:49 PM
Hi Reza,
I checked there is no ACL 101 so does this mean no NAT is configured and it is not working as per
the configuration
Regards
MAhesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide