Hi,
I am working with a Cisco Nexus C7010C chassis with 4 VDCs, using the default QoS policy maps, running 6.1(2) and I am trying to view the QoS statistics for particular interfaces. I have run a few show commands which you can see below but I am not seeing the output I would expect to see which is matches against the DSCP markings. I have tried to run the commands against different interfaces which all provide the same output shown below. The only difference is when I run the 'sh system internal qos queuing stats int eth1/2' in the default VDC which provides a different output albeit showing zero figures.
Could anyone possibly shed some light on this?
sh policy-map int eth1/2 output type queuing
Global statistics status : enabled
Ethernet1/2
Service-policy (queuing) output: default-4q-8e-out-policy
Class-map (queuing): 1p3q1t-8e-out-pq1 (match-any)
priority level 1
queue dropped pkts : 0
Class-map (queuing): 1p3q1t-8e-out-q2 (match-any)
bandwidth remaining percent 33
queue dropped pkts : 0
Class-map (queuing): 1p3q1t-8e-out-q3 (match-any)
bandwidth remaining percent 33
queue dropped pkts : 0
Class-map (queuing): 1p3q1t-8e-out-q-default (match-any)
bandwidth remaining percent 33
queue dropped pkts : 0
sh system internal qos queuing stats int eth1/2
Interface Ethernet1/2 statistics
Receive queues
----------------------------------------
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
Interface Ethernet1/2 statistics
Transmit queues
----------------------------------------
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
This is not yet implemented
