VLAN Printer Issue

[TyIT]

I have ran into a printer issue on one of my VLANs. I have new printers I am trying to put on a printer VLAN(VLAN 320) I created. This Printer VLAN currently has active printers on it with no issues. The VLAN is not full and it doesn't have a ACL on it. The printer will not pull a IP address, if it does it will not pull the GW. I have tried to statically assign the printer(multiple) and I can still not reach the printer. When I move this printer to any other VLAN it works just fine. Any ideas? Thanks.  

[Flavio Miranda]

Hi

 If you compare the port config between working and not working vlan, they have the same config? 

The port shoudl look like:

int GX/X

switch port mode access

switch access vlan 320

At least this config must be present.  So, try to joing the print with this config and see the DHCP. 

[paul driver]

Hello

Make sure the access port the printer is attached has stp portfast applied, Has negotiated the correct speed/duplex settings and you have no port security applied.
Try attaching a pc to the same port and vlan and see if you obtained an dhcp allocation.

[MHM Cisco World]

Check port secuirty, may be the mac of old printer is stick to this port.

[David Ruess]

Hello,

If the printer is in another building or on another switch make sure that VLAN is trunked all the way to the switch you are connecting to for allowing L2 connectivity.

-David