vlan routing

[susim]

I have a scenario (topology attached ) 

Current setup:

 all vlan defined on sw1 .If any unknown route Sw1 will give to sw2 .Sw2 will give to firewall FW2 . fw2 will give to r2

Required : 

 all vlan except vlan 10  (indicated in green)  has to go to fw1 for unnown route  and go out side  through R1

Other vlan should remain same like i said in current setup 

[Leo Laohoo]

You want an easy task or you want a complicated one? 

Easy answer is to define where your default-gateway is located.   So for GREEN, you put your default gateway in R1 only.  The rest in R2.  

You want a complicated task, it's called Policy-Based Routing (PBR).

[susim]

All the vlans are on the sw1 (distribution ) and sw2 is core , 

Is it a good idea GREEN vlans are direcltly going to the firewall 

[mmoulson1]

When you say 'all vlans are on sw1' do you mean as in layer 3?

Also 'unknown route Sw1 will give to sw2' do you mean via static routing?