I am new to the whole VLAN thing, so excuse my ignorance. I have successfully set up a VLAN on my primary switch which is an SGE2010. I have 3 other switches is other buildings connected in series. The next in line is another SGE2010 and then a SLM2024 and an SGE2010. Each are connected with Fiber and I'm not sure how to set up the switches so that the router controlling VLAN 2 will push IP addresses to the clients on that VLAN and allow internet access. We're using it as a guest VLAN for our customers to have internet access. I have those GBIC ports set up as trunks right now except for the SLM2024...I'm not quite sure how to set that up. The VLAN is set up on each switch exactly the same though. Any help or advice would be appreciated! Thanks!
Join us live on Tuesday, March 9 at 10 am PT (and on demand after) as we take a closer look at the WAN architecture innovations that Cisco has to offer.
We'll take your questions live during the broadcast (and after), so post them below in the comments.
Hello everybody,I am newbies with setting cisco switch.I downloaded Catalyst 2960-X Switch Getting Started Guide but I can't access to Device Manager - Express Setup according to guide.If you follow the instructions and try to keep all LEDs (exc...
To participate in this event, please use the button to ask your questions
Ask questions from Monday, March 8 to Friday, March 19, 2021
All the knowledge of these four experts at your disposal!
Cisco Software-Defined Wide Area Network (SD-WAN) provid...
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...