vPC between 2 redundant sets of nexus 5020

[tiwang]

Hi out there

we are running a a redundant set of nexus 5020 nxos 4.2.1 and another set running 5.0.3. They are inter-connected with 2 10GB fiberlinks with 50km's between given a latency of approximately ½ mSec - is there anything special to be aware of in this setup?

Can some help me with a sample setup - the setup should looke like this:

nx5k1-1 <----------------50km fiber link 1----------------------> nx5k2-1

I                                                                                                 I

I vpc domain 10                                                                       I vpc domain 11

I                       vPC connection  between sites                     I

I                                                                                                 I

I peerlink for   vPC dom 10                                                    I peerlink for vPC dom 11

I                                                                                                 I

nx5k1-2 <-------------------50km fiber link 2---------------> nx5k2-2

best regards

thomas iwang

[HUBERT RESCH]

Ok its not available yet , thx, I already saw some sample-config with peer-switch command for Nexus5000 (probable a copy paste error from a N7K config)

so I assume the system priority and the system mac under the vpc config is only used for LACP , correct ?

Thx

Hubert

[Jerry Ye]

You are correct for both system-priority and system-mac usage.

HTH,

jerry