11-07-2022 04:08 AM
Hi everyone,
I have two switches. one 9200 and another 9300.
I want to configure VRP between them, but the vrrp commands do not appear on vlan interface configuration.
I've checked and I need to execute a command "fhrp version vrrp v3" first into the devices.
I'd like to know if this command has any impact in my environment?
Today I have some vlans working in production.
First, I would like to test the VRRP in a separated vlan and after this, I will move my productions vlans to VRRP.
Thanks all.
Solved! Go to Solution.
11-07-2022 04:27 AM
If you do not have any VRRPv2 config, you ok to do that command :
When VRRPv3 is in use, VRRPv2 is unavailable. For VRRPv3 to be configurable, the fhrp version vrrp v3 command must be used in global configuration mode
11-07-2022 04:27 AM
If you do not have any VRRPv2 config, you ok to do that command :
When VRRPv3 is in use, VRRPv2 is unavailable. For VRRPv3 to be configurable, the fhrp version vrrp v3 command must be used in global configuration mode
11-07-2022 04:39 AM
fhrp version vrrp v3 <<-
is enable VRRP v3 which different than v2 in support IPv6.
so by default V2 is run and support IPv4.
so can you more elaborate what command can not enter ?
11-07-2022 04:39 AM
Thank you very much.
I've already tested and is working as expected.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: