cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
231
Views
4
Helpful
3
Replies

VSL - 6880 using built in chassis ports

GRANT3779
Spotlight
Spotlight

I have a 2 x 6880x with only the built in 16 ports on the chassis.

If I create the VSL link between these using 2 ports from each chassis, does this render the other ports to a disabled state that cannot be used? Or does this info refer only to ports on an additional switching module if added to chassis?

I have been reading this info in the following doc.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/15-0SY/configuration/guide/15_0_sy_swcg/virtual_switching_systems.html

Thanks

3 Replies 3

Rolf Fischer
Level 9
Level 9

I don't know the answer (voted "I have this problem too") but I found this discussion which might help a bit: https://supportforums.cisco.com/discussion/12465006/6880-vss-c6880-x-16p10g

Hi Rolf,

Thanks, that has helped and interesting read!

So reading this, each port groups can only have 8 ports? Are the port groups something that are preconfigured/decided or can you move ports between port groups?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card