05-04-2011 12:11 PM - edited 03-06-2019 04:54 PM
I guess the subject says it all. We just installed two new 6509s with VSS running and on the second switch (standby), there are no MAC addresses. There are servers plugged into the 2nd switch and some of those are a single NIC. So, why on those ports wouldn't I see a MAC address.
Is there a command that is needed to make those visible? What has me puzzled is that all the servers on switch two operate just fine.
Flip Hayes
05-04-2011 03:22 PM
Hi Flip,
What command are you trying? You may some thing like following :
show mac-address-table dynamic interface
OR
show mac-address-table dynamic switch <1|2> module
thanks,
rahul.
05-04-2011 03:26 PM
Flip,
The 2 6509 work as one logical switch. If VSS is working correctly, you should not even have access to the 2nd switch (stand-by).
Reza
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide