Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
527
Views
0
Helpful
1
Replies

VSS Dual Active Detection configuration question

rshum
Level 1
Level 1

‎06-25-2012 07:42 AM - edited ‎03-07-2019 07:26 AM

In IOS verson 12.X there was a Bidirectional Forwarding Detection configuration however in IOS 15.0 this isn't available at least not with the same syntax. Is this feature not available in 15.0?

In 12.X this was the syntax of the command:

switch virtual domain <number>

dual-active pair interface GigabitEthernet1/X/X interface GigabitEthernet2/X/X bfd

Labels:
0 Helpful
1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

‎06-25-2012 08:06 AM

BFD for VSS dual active detection is deprecated in newer versions of IOS.  The only 2 options are: Fast hello and ePAGP.

HTH

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card