10-24-2012 06:44 AM - edited 03-07-2019 09:39 AM
Dear all,
I have configured VSS in two core distribution with port-channel and eigrp, but when I type show ip route it is showing only one side traffic(one Port-channel). If I shutdown that port-channel, I am unable reach the vss. Is there any command to do the load balancing with port-channel.
Regards
Selvam
10-24-2012 07:08 AM
Hi,
So, you have a switch that connected to a VSS pair via a portchannel?
if yes, than if you shut the portchannel all links in that portchannel go down. You need to down a port in the portchannel and not the portchannel itself
What is the design look like?
HTH
10-24-2012 10:34 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
On non-VSS devices, load sharing commands, i.e. what's available, and default vary by platform. Most newer platforms support multiple options.
On VSS devices, it ignores load sharing between VSS members, as VSS tries to keep all dataflows from crossing VSL links. If there are multiple links on same member, I suspect that device load sharing options might apply.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide