We are getting this Msges why and when?

[c82_patel]

GUJ_CS01_AHM#show config

%% Non-volatile configuration memory is being accessed, Try again later

GUJ_CS01_AHM#

[Jon Marshall]

Hi

You are getting this message because someone else is logged into the same device and has issued a "show config" at the enable prompt.

Their "show config" has not completed and until it does you will not be able to run your "show config".

If you type "who" at the enable prompt it will show you who else is logged in to the device.

HTH

Jon