cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
310
Views
0
Helpful
1
Replies

What are these errors?

sivaalthi85
Level 1
Level 1

Hi Friends,

Can  somebody please explain what are below highlighted errors.

GigabitEthernet0/13 is up, line protocol is up (connected)

  Hardware is Gigabit Ethernet, address is 503d.e508.4b0d (bia 503d.e508.4b0d)

  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX

  input flow-control is off, output flow-control is unsupported

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input never, output 00:00:01, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     1291651 packets input, 208496420 bytes, 0 no buffer

     Received 10972 broadcasts (303 multicasts)

     0 runts, 0 giants, 0 throttles

     10 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     0 watchdog, 303 multicast, 0 pause input

     0 input packets with dribble condition detected

     2390415 packets output, 2232601876 bytes, 0 underruns

     0 output errors, 0 collisions, 4 interface resets

     0 babbles, 0 late collision, 0 deferred

     0 lost carrier, 0 no carrier, 0 PAUSE output

     0 output buffer failures, 0 output buffers swapped out

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

Duplicate post. 

Review Cisco Networking for a $25 gift card