09-07-2014 08:59 PM - edited 03-07-2019 08:39 PM
What is the command to check the changes in the spanning-tree topology?
Solved! Go to Solution.
09-07-2014 09:46 PM
Hi,
Few commands which would help are:
1- Show spanning-tree detail
2-show spanning-tree detail | in ieee|from|occur|is exec >> This will give from were the changes occuring- Ex:
C6K1#show spanning-tree detail | in ieee|from|occur|is exec
VLAN0001 is executing the rstp compatible Spanning Tree protocol
Number of topology changes 9536 last change occurred 00:00:29 ago
from GigabitEthernet4/6
3- show spanning-tree active *& show spanning-tree root >> Will give you the root information.
4- show spanning-tree inconsistentports >> If there are any port which are inconsistent state due to STP features.
STP running MST:
===============
show spanning-tree mst configuration >> Need to check and match the same outputs with the other switches running in the same MST domain/region.
show spanning-tree mst detail
show spanning-tree mst <name of the region>
Debug on STP:
============
debug spanning-tree events/bpdu >> would be good but to be run with more cautious.
HTH
Inayath
*Plz rate if this info is usefull.
09-07-2014 09:46 PM
Hi,
Few commands which would help are:
1- Show spanning-tree detail
2-show spanning-tree detail | in ieee|from|occur|is exec >> This will give from were the changes occuring- Ex:
C6K1#show spanning-tree detail | in ieee|from|occur|is exec
VLAN0001 is executing the rstp compatible Spanning Tree protocol
Number of topology changes 9536 last change occurred 00:00:29 ago
from GigabitEthernet4/6
3- show spanning-tree active *& show spanning-tree root >> Will give you the root information.
4- show spanning-tree inconsistentports >> If there are any port which are inconsistent state due to STP features.
STP running MST:
===============
show spanning-tree mst configuration >> Need to check and match the same outputs with the other switches running in the same MST domain/region.
show spanning-tree mst detail
show spanning-tree mst <name of the region>
Debug on STP:
============
debug spanning-tree events/bpdu >> would be good but to be run with more cautious.
HTH
Inayath
*Plz rate if this info is usefull.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide