which memory do i buy

[dudu_2030]

hi pls i need some help

the memory utilization of my cat 6513s abnormally grew very high last week

it came back to normal after i turned off all debugs...

my bossed asked to know how much it would cost to upgrade the DRAM (which i believe is d memory responsible for holding routes, and other running info)

i saw on http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/qa_c67_457347.html that there is a different memory for Sp and a different one for RP.

pls help confirm if these part numbers are correct

MEM-Sup720-SP-1GB= (SP)

MEM-MSFC3-1GB= (RP)

dose it mean i have to buy two per SUP engine (WS-Sup720-3B) cos there are two installed in the switch

[Antonio Knox]

Let me start by saying that it is not a good idea to run debugs in any circumstance outside of times when they are necessary for troubleshooting.  You should keep this in mind when using debug.  Only debug what you need (be as granular as possible) for as long as you need and not a minute longer.  Careless use of it can cripple your device, rendering it unusable no matter how much memory you install.  Now to your question:

Yes, you should upgrade both memory modules.  Look here (if you haven't already):

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/qa_c67_457347.html

Message was edited by: Antonio Knox