Hi People,
I have purchased a new WiSM 2 and my catalyst 6509-E is failing to detect it. Here are the details of the switch:
1. supervisor engine: vs-s720-10g-3cxl
2. ios image: s72033-advipservicesk9_wan-mz.122-33.SXI10.bin
3.
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 8 Intrusion Detection System WS-SVC-IDSM-2 SAD103501HP
2 4 FRU type (0x6003, 0x3B2(946)) WS-SVC-WISM2-K9 SAL1648T81L
5 5 Supervisor Engine 720 10GE (Active) VS-S720-10G SAL1438TRNP
8 48 CEF720 48 port 1000mb SFP WS-X6748-SFP SAL1441W4T2
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0019.2fa7.2d3a to 0019.2fa7.2d41 6.2 7.2(1) 6.0(1)E1 Ok
2 f0f7.5569.19a0 to f0f7.5569.19af 1.1 Unknown Unknown PwrDown
5 0026.cb61.9438 to 0026.cb61.943f 3.2 8.5(4) 12.2(33)SXI1 Ok
8 1cdf.0fb3.ca20 to 1cdf.0fb3.ca4f 2.4 12.2(18r)S1 12.2(33)SXI1 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 IDS 2 accelerator board WS-SVC-IDSUPG ADBG6260031 2.5 Ok
5 Policy Feature Card 3 VS-F6K-PFC3CXL SAL1441W2NZ 1.2 Ok
5 MSFC3 Daughterboard VS-F6K-MSFC3 SAL1443XXF9 5.1 Ok
8 Centralized Forwarding Card WS-F6700-CFC SAL1442WLLW 4.1 Ok
Mod Online Diag Status
---- -------------------
1 Pass
2 Not Applicable
5 Pass
8 Pass
thanks.
ronnie
