cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
303
Views
0
Helpful
1
Replies

Wrong boot file on 9300 Switch

Hey, i have tried to change a 9300 switch to another version so that it could be stacked along side 2 others, 
I have added the wrong boot and now the switch ends up in the rommon. 

I was wondering if there was a way to change the default boot config back to the version it is getting from the flash: file

As of right now i am just looking for a way to ensure it won't be stuck in rommon in case of a power outage or a reset. 

Thank you in advance. 

1 Accepted Solution

Accepted Solutions

marce1000
Hall of Fame
Hall of Fame

 

  - Check this  thread  :  https://community.cisco.com/t5/switching/boot-from-usbflash-on-rommon-mode-cisco-9300-switch/td-p/3855489

  M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

1 Reply 1

marce1000
Hall of Fame
Hall of Fame

 

  - Check this  thread  :  https://community.cisco.com/t5/switching/boot-from-usbflash-on-rommon-mode-cisco-9300-switch/td-p/3855489

  M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '