Hi, Im configuring a switch model WS-C2960G-48TC-L and GigabitEthernet0/45 - 48 which has both RJ45 and fiber port available. I'm connecting to the RJ45 port and i'm wondering if there is any special command required because i cant get the port working, it will show as "not connected". The port is already unshut:
interface GigabitEthernet0/47
description MY00XR01 Gi0/11
switchport trunk allowed vlan 1,500
switchport mode trunk
udld port aggressive
storm-control broadcast level 25.00
!
interface GigabitEthernet0/48
description MY00XR02 Gi0/11
switchport trunk allowed vlan 1,500
switchport mode trunk
media-type rj45
duplex full
storm-control broadcast level 25.00
sh interface status
Gi0/47 Gi0/11 notconnect 1 auto auto 10/100/1000BaseTX
Gi0/48 Gi0/11 notconnect 1 full auto 10/100/1000BaseTX
However when i apply the same config on interface GigabitEthernet0/43 - 44, the port immediately came up and CONNECTED :
interface GigabitEthernet0/43
description MY00XR01 Gi0/11
switchport trunk allowed vlan 1,500
switchport mode trunk
udld port aggressive
storm-control broadcast level 25.00
!
interface GigabitEthernet0/44
description MY00XR02 Gi0/11
switchport trunk allowed vlan 1,500
switchport mode trunk
udld port aggressive
storm-control broadcast level 25.00
>>sh interface status
Gi0/43 MY00XR01 Gi0/11 connected trunk a-full a-1000 10/100/1000BaseTX
Gi0/44 MY00XR02 Gi0/11 connected trunk a-full a-1000 10/100/1000BaseTX
