cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3246
Views
0
Helpful
10
Replies

WS-C3560-8PC-S routing performance and capability

yuhuiyao
Level 1
Level 1

All,

What is the routing performance of WS-C3560-8PC-S? Can I get 100Mbps out of the interface?

1 Accepted Solution

Accepted Solutions

You are right, but you can take the information provided on this page:

http://www.cisco.com/en/US/products/hw/switches/ps5528/prod_models_comparison.html

and come up with the numbers from the previous page.

Based on the page above, the 8port switch produces 2.7 Mpps which based on my calculations taken from the 2 models listed in the initial link rates about 3.6Gbps..

View solution in original post

10 Replies 10

Mohamad Qayoom
Level 3
Level 3

I believe catalyst 3560 switches are going to reach End-of-life very soon.

Here is a link:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps5528/eol_c51_519208.html

Thanks,

Mohamad

Mohamad,

That's incorrect !

The link you've posted is related to the Advanced IP Services feature set, not the hardware itself.

__

Edison.

Agreed. Mohadmad is not correct.

My bad, I am sorry.

Edison Ortiz
Hall of Fame
Hall of Fame

You sure can, please visit this link:

http://www.cisco.com/web/partners/tools/quickreference/index.html

and select any of the documents under 'Switch Performance'.

HTH,

__

Edison.

I have read that before. It did not mention any performance about routing. I am wondering if routing can have the same performance as swtiching.

See the column L2/L3 ? 3560 indicates L3 so those stats where measure with routing involved.

HTH,

__

Edison.

There is nothing about C3560-8PC, the 8 porter I am looking for.

You are right, but you can take the information provided on this page:

http://www.cisco.com/en/US/products/hw/switches/ps5528/prod_models_comparison.html

and come up with the numbers from the previous page.

Based on the page above, the 8port switch produces 2.7 Mpps which based on my calculations taken from the 2 models listed in the initial link rates about 3.6Gbps..

Joseph W. Doherty
Hall of Fame
Hall of Fame

Depending on which specs you examine, you might be able to obtain full wire rate from all ports (for either L2/L3). If true, answer to your question is yes. If not true, very likely switch's L3 performance is (much) more than 100 Mbps.

PS:

Where the specs conflict:

Table 2 in http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps5528/product_data_sheet09186a00801f3d7d.html shows, for performance, 32 Gbps forwarding bandwidth (all 3560s?) and 2.7 Mpps (Cisco Catalyst 3560-8PC), but in Edison's first reference, although the 8 port 3560 isn't listed, other 10/100 3560s are noted with less than 32 Gbps.

The Mpps rating, 2.7 Mpp, is what's needed for wire speed, only whether 3.6 Gbps fabric bandwidth is provided is unclear.

Review Cisco Networking for a $25 gift card