10-21-2009 05:34 AM - edited 03-06-2019 08:13 AM
I have to use xmodem to recover IOS for switch 3750 because the current ios was lost.
when i tried to type: copy xmodem: flash:c3750-ipbasek9-mz.122-35.SE5.bin
i got "Begin the Xmodem or Xmodem-1K transfer now...". So I began send file with xmodem, I got the error prompt "Xmodem operation was canceled by remote peer". I also could not finish the file transfer.
Please help me and give any advice, thx a lot!
10-21-2009 06:07 AM
Hi,
Could you please check you hyperterminal settings once.
Also go though this link..
HTH
Inayath.
10-02-2013 09:27 AM
dear
write this " flash_init" , then do the transfer to Xmodem ............... the error will be solve,
02-17-2024 08:00 AM
flash_init worked! Thank you very much. However, once my .bin file was copied to flash, it will not boot to the new .bin. I have an old version of the .bin that I was trying not to boot from anymore. Perhaps there is a way to erase the old ones and leave only the new file in flash, that way it could only boot from the new. Could you please give me the cli to boot from the new .bin? I tried "boot" not sure what else to type.
Thanks in advance,
TC
10-06-2013 07:35 PM
Hi.
The terminal is not ready to copy the file, either the flash isn't ready or there's not enough space, like Rawa said, from rommon type flash_init to get it ready.
And second: make sure there's enough space in flash, dir flash: to check free space.
Regards.
Wilson B
12-18-2019 03:39 AM
Using flash_init worked. Thanks for the advise
02-21-2021 06:58 AM
thank you the flash_init solve the error message.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide