Technical Documentation Ideas

I need a CAD model or technical drawing for the mounting bracket(s) for the C9500-24YAC.P/N: 700-111221-01 Rev A0Issue: SFP modules used in front ports requires adapters that cause mating fiber to stick too far out from the front our our rack.  We ne...

I've just downloaded the Catalyst 9000 Series Visio stencils and I still do not see any shapes for the Cisco Catalyst 9404 chassis. Are there plans to include these stencils in a future release? We've deployed many of these and we're having to use a ...

Hello, While searching through Cisco's Visio Stencils page, I have been unable to find the stencil for the Catalyst 3560G Series PoE-24. I have searched through the 'Switches - Catalyst 3560' and the 'Switches - Catalyst 2560CS' packages, and was una...

Hello, I would like to know what the Mean Time Between Failure (MTBF) or Failure Rate value is for PN: : C9500-40X-E. 

I need the Vis3 Stencil for the RV340, but I am not finding it anywhere on the internet, does anyone know where it is possible to download it?

The page with Visio stencils is listing ISA3000 and IC3000 is physically identical except the name on the faceplate. Can we add one new stencil based on ISA3000 with the IC3000 naming?   https://www.cisco.com/c/en/us/products/visio-stencil-listing.ht...

So my phone froze up and I held down the power button. When it rebooted it showed that I had missed a call from +1552546429 when I called it I got an answering service that said thank you for calling sorry and leave a message my first pound a bunch o...

All, I've been tasked with trying to find out all extensions in the Call Manager that are forwarded off premise.  I'm a TDM guy and have very limited knowledge of UC, so If you have any ideas or give me an answer please keep it as vanilla as possible...

Hi   I don't see a Visio stencil for the Cisco 4221 router listed so it's challenging to produce Visio engineering drawings without them.    Can the Cisco 4221 be created please?   Regards   Jon

I would like to submit a request for Cisco branded Visio stencils around our Firepower 1000 Series and 2000 Series Next Generation Firewalls to be posted here: https://www.cisco.com/c/en/us/products/visio-stencil-listing.html

Need Visio stencils for the Firepower 1100 Series - specifically in my case for the 1140.

In the Optical Networking - NCS 2000 stencil, one of the shapes titled NCS2K-400G-XP has the TX and RX locations swapped on just the port 11 and port 12 from what is actually on card.  Can the shape be updated and reposted?