cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
415
Views
0
Helpful
2
Replies

3511 factory reset other than from menu?

jmatteo
Level 1
Level 1

Began setup of 3511 MCU to integrate with Call Manager 4.0. Followed steps in setup guide but along the way something got hosed.

Cannot get to reset screen to go back to factory defaults. It gets to an SNMP startup error and just hangs. I receive the following info during startup:

Log Tasks started

rvLOGGER: No rvLogRegister: registring index:0x conn3000ection.

rvLogRegister: registring index:0x

rvLOGGER: Re2000ady to establish

VxWorks (for ViaIP MPC755_MPC8260) version 5.5.

Kernel: WIND version 2.6.

Made on Dec 18 2003, 10:25:51.

Boot line:

motfcc(0,0)rvhost: e=10.2.1.245:FFFFFF00 g=10.2.1.249 o=±

CONFIG: stopChange: cmEmEncode() failed new connection.

MCU |Could not load file into CFG manager

MCU |MCU Configuration Init failed

MCU |Failed initializing configuration

MCU |SNMP Trap not Initialized yet

MCU |SNMP Trap not Initialized yet

2 Replies 2

s-doyle
Level 3
Level 3

This looks like some hardware issue.

Appears that's what it was. RMA was issued.

Attempted to downgrade to earlier code using the "wakeup" feature without success.