Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Began setup of 3511 MCU to integrate with Call Manager 4.0. Followed steps in setup guide but along the way something got hosed.Cannot get to reset screen to go back to factory defaults. It gets to an SNMP startup error and just hangs. I receive t...
Attempting to document the server recovery process for Call Manager 3.3(3) for my own records, and at customer request.Does the "Same Server Recovery" need to be flagged to restore a Publisher server from failure? Assuming backup is current. Does t...
Anyone have this working. I have a 77 access code setup to inteface to the paging system. The router FXO port picks up when 77 is dialed but disconnects after approximately 5 seconds. Call Manager FXO LoopStart port has been tried as inbound/outbo...
Can this be done? I import phones initially via .csv import from Access Database but man am I tired of adding route patterns for a Least cost VOIP network with 6 sites. I also have several fxo sites that need individual lines so that is another set...
Network topology:Fax-ATA186-3550PWR-6608-T1 Services PRIor:Fax-ATA186-3550PWR-2651XM w/ T1 PRICannot get certian fax machines to properly transmit faxes to specific numbers. Majority of faxes are working properly, all receive properly. Transmit on ...
Thanks to both of you for your input. Recovery, as I'm referring to it here would be from a hardware (HDD) failure.One last question. Same server recovery is a rebuild of call manager only on the existing OS platform? Not sure how else you would b...
Do the problem phones happen to be color 7970 phones? If yes, update the firmware, to the newest release. I experienced the same bug and message with 7970's even though Call Mananger was functioning properly.
Cisco or cisco Be sure once you log in, you create a cdradmin user or give another user Admin rights to CDR or you will not be able to log in a second time
Got this working with the above config. No adapter or pagepal type unit needed. Cross-connect from Valcom location was mislabeled. After tracing out the line, and correctly punching, all is well. Thanks for your replies.
