call speed set in cisco sx 20

manjunatha.k · ‎12-05-2017

hi

can anyone say how can we freeze setting on cisco telepresence settings

on call speed

when device is boot speeed is changeing

Wayne DeNardi · ‎12-05-2017

You can set the default call rate on the endpoint, and that should survive a reboot, unless there is something else that is re configuring it (CUCM, TMS Template, etc).

The default call rate can be found on the web interface under Setup > Configuration > Conference > DefaultCall > Rate.

or can be set with the command:

xconfiguration Conference DefaultCall Rate: 768

On the configuration page listed above, you can also define the Max rates which you could also apply to limit what can actually be done from the endpoint.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

manjunatha.k · ‎12-06-2017

yes we do have CUCM for provision to all Cisco end points.

and also we have TMS for managing and address book for those TP room

need help me where we can configure speed setting in CUCM and also TMS also

Wayne DeNardi · ‎12-06-2017

In TMS, you can set up configuration templates and assign those to endpoints (see Using Configuration Templates section of the TMS Admin Guide)
In your CUCM, you can define the bandwidth under the region settings.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.