03-27-2014 12:18 PM - edited 03-18-2019 02:48 AM
Hi All,
I have a situation where I am trying making a call from HQ to a phone connected to a PBX at a remote site. I am receiving a Fast Busy signal when I am making the call. The call is supposed to go through our IP network to the remote site Voice gateway then out the T1/CAS interface to the PBX.
Within CUCM, the call routing looks to be set up correctly and the dial pattern points to the remote gateway T1 Interface. Also within CUCM, that voice gateway and T1 interface are registered.
Can anyone please provide some insight into this?
Thank you,
Duy
05-06-2014 12:53 PM
You need to post HQ and Remote side Configurations here because its hard to tell without config files, it can be issue with dial pattern command or remote routers connectivity issue but cant say for sure until I see config here
05-07-2014 11:54 PM
Try to use DNA to know exactly where the problem lies...........
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide