cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3095
Views
6
Helpful
4
Replies

Cisco Codec Pro - Power Usage

JesseJames7761
Level 1
Level 1

Looking for power usage of the cisco codec pro. In the datasheet and admin guide it only states 

 

Autosensing power supply
• 100–240Vac, 50/60Hz

 

I require typical power consumption in watts. Someone please assist.

1 Accepted Solution

Accepted Solutions

Wayne DeNardi
VIP Alumni
VIP Alumni
●  100 to 240 VAC, 50/60 Hz, 12V DC input
●  Standby 6W, average 20W, peak 70W
Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

View solution in original post

4 Replies 4

Wayne DeNardi
VIP Alumni
VIP Alumni
●  100 to 240 VAC, 50/60 Hz, 12V DC input
●  Standby 6W, average 20W, peak 70W
Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

You can check below link to get the exact power ratings.

PDF PAGE : 18 section H. for codec pro.

https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/room-kit/installation-guide/codec-pro-installation-guide-en-fr-es-pt-it-de.pdf

 

You can calculate the volts to AC by checking this post.

https://www.voltagevalet.com/pages/modifying-electricity

 

Please rate my response.

Agree with this post.

Incorrect.  This is for the Quad Camera Only.  In the Install manual on p16, it says the CODEC's power is 1.3A at 110V and .6A at 240V.  We can calculate about 143 Watts power consumption for the CODEC Pro by itself.