05-03-2015 10:18 PM - edited 03-18-2019 04:25 AM
Hi,
I've installed my SX-10 but there is a message at the upper right side that it is 'Not Registered'.
What does it mean and what do i have to do?
Thanks!
Solved! Go to Solution.
05-03-2015 10:29 PM
It means it is not registered with a CUCM or VCS etc.
See the admin guide for how to configure it if you are in fact using a callcontrol device such as a CUCM or VCS.
If you are using it as a "stand-alone" system, then you can remove this message by changing the "SystemUnit ContactInfo Type" to one of the other options, i.e. IP address, System Name and this will then be displayed instead - or set it to "None" to not have anything displayed - again see the admin guide.
/jens
Please rate replies and mark question(s) as "answered" if applicable.
05-03-2015 10:29 PM
It means it is not registered with a CUCM or VCS etc.
See the admin guide for how to configure it if you are in fact using a callcontrol device such as a CUCM or VCS.
If you are using it as a "stand-alone" system, then you can remove this message by changing the "SystemUnit ContactInfo Type" to one of the other options, i.e. IP address, System Name and this will then be displayed instead - or set it to "None" to not have anything displayed - again see the admin guide.
/jens
Please rate replies and mark question(s) as "answered" if applicable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide