02-24-2016 12:41 AM - edited 03-18-2019 05:36 AM
My SX10 can not receive remote(SX20) audio/video,but remote can receive my audio/video.
About SX10 setting,I only configure private ip setting ,In ASA,I have configured NAT setting and inside/outside access rule all pass.
what setting I miss?
PLS help me!
thanks
Eddie
02-24-2016 12:52 AM
You would need to open Audio/Video UDP port range 2326 - 2487 for incoming traffic.
regards,
Acevirgil
02-24-2016 12:58 AM
About incoming traffic,
I already open all port of TCP/UDP in ASA,
but still can't work.
Eddie
02-24-2016 01:12 AM
Can you tell exactly how's the SX10 is deployed. Do you have a call control (CUCM/VCS) and call goes through Expressway-C to E then to SX20. Or is this a stand alone setup?
regards,
Acevirgil
02-24-2016 01:42 AM
I just stand alone setup,no any call control.
SX10 only setup network setting with private IP,other setting is default
And I have NAT setting in the ASA.
Eddie
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide