Hello Folks,
We have connected 6 PTZ4K Cameras to Codec EQ using unmanaged ethernet switch and and HDMI Switch.
Codec detected all 6 Cameras as you can see below.
xstatus cameras Camera Connected
*s Cameras Camera 1 Connected: True
*s Cameras Camera 2 Connected: True
*s Cameras Camera 3 Connected: True
*s Cameras Camera 4 Connected: True
*s Cameras Camera 5 Connected: True
*s Cameras Camera 6 Connected: True
** end
However, Serial Number Mapping for Camera ID 4-5-6 keeps on getting changed after device reboot.
xStatus Cameras Camera SerialNumber
*s Cameras Camera 1 SerialNumber: "88c9e8ec95f4"
*s Cameras Camera 2 SerialNumber: "88c9e8ec9689"
*s Cameras Camera 3 SerialNumber: "88c9e8ec9670"
*s Cameras Camera 4 SerialNumber: "88c9e8ec9669"
*s Cameras Camera 5 SerialNumber: "88c9e8ec9542"
*s Cameras Camera 6 SerialNumber: "88c9e8ec9665"
** end
We tried to hardcode mapping with - xConfiguration Cameras Camera 4 AssignedSerialNumber:"88c9e8ec9669" command but it throws below error for camera 4-5 and 6.
xConfiguration Cameras Camera 4 AssignedSerialNumber:"88c9e8ec9669"
*r Configuration (status=Error):
*r Configuration Reason: "No match on address expression."
*r Configuration XPath: "Configuration/Cameras/Camera[4]/AssignedSerialNumber"
** end
Has anyone did this kind of setup. I have 2 queries.
1. Can we hardcode Camera ID and Serial Number with Macros. If yes, anyone have macros required for this.
2. Can we assign Static IP address to PTZ4k Cameras if we want to achieve camera control through AV setup.
