Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,
We have CUCM 14.0 SU3 Cluster of 2 Nodes on same UCS Hardware.
SIP Trunk to Avaya PBX is showing "no service". and we are not able to make calls to Avaya PBX from Cisco PBX. However, surprisingly calls from Avaya PBX are landing perfectly...
Hello Folks,
We have connected 6 PTZ4K Cameras to Codec EQ using unmanaged ethernet switch and and HDMI Switch.
Codec detected all 6 Cameras as you can see below.
xstatus cameras Camera Connected*s Cameras Camera 1 Connected: True*s Cameras Camera 2...
Hello Folks,
We have Codec EQ with Speaker Track 60.
We want to change default View when VC is powered or when Camera Wakes from Standby Mode.
Please see the attached image. The area marked should not be visible when Camera Wakes up from the standby ...
Hello Guys,
I have configured SIP Line from Service Provide on the 4451 ISR Router. Link is not getting registered.
blr-vg-6a-01#show sip-ua register status --------------------- Registrar-Index 1 --------------------- Line peer expires(sec) reg surv...
Hi Roger,
Thanks for your reply.
Not sure, how we are getting Calls from Avaya PBX via same SIP Trunk even if its status is "No Service".
In RTMT We can See. CCM_SIP_503_Service Unavailable for Calls made from Cisco to Avaya PBX.
Below is the working configuration for TATA SIP Trunk.
voice class tenant 100registrar 1 ipv4:10.60.XX.XX:5061 expires 120 - This is TATA SBC IP addresscredentials number 0091XXXXXXX100 username 0091XXXXXXX100@10.60.XX.XX password 0 XXXXX realm 0091X...
