Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
3794
Views
5
Helpful
1
Replies

CTS 1300 Display Diagnostics: Error

Daniel Delorme
Level 1
Level 1

‎02-15-2012 12:37 PM - edited ‎03-17-2019 10:50 PM

we have an error with our CTS 1300.

it show Display Diagnostics: Error into our status details and i want to resolve this.

is there someone here who have this issue before?

we have this problem before with the version 1.7.2 and we just upgraded the software to 1.8.1 and we still have this error message.

Display_Hardware_ver1.3
Display_ModelCTS-DISP-65-GEN3

we also changed the codec ( for anothere reason) and the message is still there..

looks like the display can't run the diagnostic.

thanks

Daniel

Labels:
0 Helpful
1 Reply 1

Jeff King
Cisco Employee
Cisco Employee

‎02-16-2012 04:11 AM

Daniel,

On a Gen 3 display there are 2 HDMI ports. If the HDMI cable is connected to the wrong HDMI port then you will see this Diagnostic error. The Primary HDMI port is the farthest from the center. Check and see which port that the HDMI cable is connected. Also check the firmware for the GEN 3 display. The firmware should be in the range of 21.xx.

JD King

Customers Also Viewed These Support Documents