10-07-2014 01:41 PM - edited 03-18-2019 03:30 AM
hi
the CTS-PHD1080P12XS2 PrecisionHD Camera 1080p12x is supported on SX80 codec.
i've one sx80 witch speaker track and think buy a 3th camera CTS-PHD1080P12XS2 but no found document to support this camera on SX80.
10-07-2014 02:16 PM
According to the SX80 Data Sheet, it only supports the following codec/camera combinations:
You can take a look at the SX80 Installation Sheet, to see how you can use the above cameras.
11-18-2014 08:58 PM
There's a DB9 for serial control of cameras. PHD1080p12x and PHD720p both worked for when I tried with the SX80
Use the same pin-out for camera cable as you would for a C60, will need separate power supply for the camera though, as there's no DC power from the SX80 camera serial port.
Was also able to daisy chain camera control (same method as for C60, using RJ11 to RJ45).
09-25-2017 01:06 AM
Yes, it is supported. Please check the Precision HD Camera Guide on Page 16.
09-25-2017 07:41 PM
The CE9 Relsase notes (Page 9) says that the 1080p 12x camera is only partly supported on an SX80. Basic PTZ is supported. Software updates are not supported, and daisy chaining, while it may work, is not supported.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide