EX60 PIP when connected as a PC Monitor

[Networker .]

Hi 

I am using an EX60 with firmware TC7.3.7 registered to cucm 11.0

The Ex60 is connected as a PC monitor.

When doing a point to point video call , the remote party is shown as full screen in the EX60 while on call.Is it possible to have Picture in Picture(PIP) so that the user can use the screen, as both a PC monitor and video endpoint

Thanks

[Patrick McCarthy]

You have options on how to split the screen - you just have to go through the layout options to see what works best for you. See the user guide, layout options. 

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/ex-series/tc7/user-guide/ex60-ex90-user-guide-tc73.pdf

[Patrick Sparkman · Accepted solution]

Refer to pg 31 in the link Patrick provided, when in a call and with a PC connected to the EX60, you should see a "Preview PC" option on the Touch 8.  This will allow you to preview your computer screen, and still see the video conference in a PIP on the screen, you can then move the PIP around the screen using the Touch 8.  To present your content, select the "Share" option on the Touch 8 while you're previewing your PC content.