02-15-2013 12:04 AM - edited 03-18-2019 12:36 AM
Hello!
I have installed CUCM 9.0 on VmWare, with demo licenses.
After installation, I launched the configuration wizard, and enable autoregistration.
Phone 7945 auto registered successfully.
In the Provisioning Wizard to EX 90 I point address CUCM - 192.168.135.2, but I get an error:
CUCM Service is unavailable.
How can i register EX90 on CUCM?
02-15-2013 04:46 AM
Hi Evgenly. Good morning. Can you list the SW version for the EX90 that your using? I'm assuming TE6 perhaps?
Double check DNS to see if the EX90 can resolve the address that you have listed. If it it can't, it may not be able to reach it. It may help to navigate to the log pages to and upload the all.log if you wish after you tried provisioning it one more time to see why its complaining. May help here instead of guessing.
Let us know.
Thanks in advance.
VR
P2
02-17-2013 06:32 PM
Hi, Patrick.
Thanks for the reply.
The problem was in the network configuration. EX90 now registered properly.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide