How do you enable video on IP communicator

[Richard Bradfield]

Just got Vt advantage 2.0 to run with my IP communicator 2.0, but does not connect

notes say IP communicator has to be video enbled,

but there is NOT an option in the CallManager 4.0.2 sr2c to enable video on the communicator setup page unlike the normal ip phone which has video capabilities enabled/disabled input

please help

[Brandon Buffin]

You must have CCM 4.1(3)sr1 to use VT Advantage with IP Communicator. Please see the following link for confirmation.

http://www.cisco.com/en/US/products/sw/voicesw/ps5475/products_administration_guide_chapter09186a00805f08bc.html#wp1110915

Hope this helps. If so, please rate the post.

Brandon