08-10-2016 07:49 PM - edited 03-18-2019 06:15 AM
Hi All,
Would just like to know if the codec of profile52 is removable or it is already built in to the base?
We are planning to replace the codec since it was found defective. Thanks
Appreciate your response.
08-11-2016 07:57 AM
Hello,
Yes. C60 is removaible.
Open the front cover.
Disconnect the wires.
Unscrew the bolts.
br Oleksandr
08-11-2016 11:28 AM
It should be removable, but I haven't found any kind of detailed diagram or instructions that go into specifics of the various TelePresence Profile endpoints that might show steps of how to remove the C60, so you're really going to have to just take a look and figure out how to remove it.
08-16-2016 03:45 AM
Below are the instructions on how to remove the C60 codec for the Cisco TelePresence Profile Dual 52 and 55 system.
To remove the Profile C60 codec, do the following:
Step 1 Open the front panel.
Figure 1-1: Open the Panel
Step 2 Disconnect codec power, camera, LCD, microphone, and other cables. See Figure 2-1.
Figure 2-1: C60 Codec Cables
Step 3 Remove the four mounting bracket Allen screws from the codec with a 2mm Allen wrench. Keep all the screws. See Figure 3-1.
|
Figure 3-1: Removing the Codec Bracket Allen Screws
Step 4 Carefully remove the codec from the pedestal cover.
This completes Removing the TelePresence Profile Dual 52 and 55 C60 Codec.
Best Regards,
Rishabh
--
Please remember to rate responses and to mark your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide