10-13-2012 02:04 AM - edited 03-17-2019 11:58 PM
Hi experts,
We are trying to make an Edge95 MXP use H.264 as codec for presentation towards Radvision/Scopia MCU using H.323 as signaling protocol and H.239 as presentation standard. But it only seems to be using H.263 as codec.
When presentation is started from Edge95 MXP endpoint, only main video is shown on remote side (unless H.263 is used for presentation)
When presentation is started from remote side, only main video is shown on Edge95 MXP endpoint (unless H.263 is used for presentation)
- H.239 is obviously enabled, all video codecs are enabled (H.263 and H.264)
- Video Quality is set to Motion for Main Cam and Sharpness for PC
See attached Wireshark packet capture.
--
Filippo Zangheri
Solved! Go to Solution.
10-13-2012 08:42 PM
Hi,
This is expected behavior for MXP . It will always use h263 for presentation / duo video .
Kind regards,
Dharmmesh
10-13-2012 02:27 AM
The following is extracted from frame #65, which is a TerminalCapabilitySet message coming from Radvision room towards Tandberg endpoint:
It shows H.239 support under H.264 video capability. While in frame #67 Tandberg endpoint only advertises its H.239 ExtendedVideoCapability under H.261 and H.263 codecs:
--
Filippo Zangheri
10-13-2012 08:42 PM
Hi,
This is expected behavior for MXP . It will always use h263 for presentation / duo video .
Kind regards,
Dharmmesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide