Make use of traversal call instead of Non-traversal on Cisco VCS-C

[Elie Sbat]

Hi,

I have a Cisco VCS Control currently running 20 non-traversal and 100 traversal license. I need once I initiate a session from Cisco Jabber client to one of the cameras (Studios) . I want the VCS to consume a traversal call license ?

Is this possibe ?

[Magnus Ohm · Accepted solution]

Hi

If you enable interworking and call from jabber on sip to an H323 endpoint. SIP<-> h323 will consume a traversal

Lisence.

/Magnus

Sent from Cisco Technical Support iPhone App

[Elie Sbat]

Hi,

let me tellyou the setup. I have a Cisco VCS-C and Tandberg Camera. Codec C60 .

I enables Interworking on Cisco VCS but on Cisco Jabber there is no option choose the protocol.

The camera is running on SIP.

[Magnus Ohm · Accepted solution]

Ok on the c60 disable sip. Register it on h323 and call it from the jabber client. If you use an e164 alias i think you need a search rule that adds the @domain.com as a suffix. If you dont type this in manual when you are making the call.

/Magnus

Sent from Cisco Technical Support iPhone App

[Elie Sbat]

Magnus,

how to make it register on H232 ? where to find the alias ? I am very novice in Teleresence

I know how to reach to H232 configuration an SIP but there what field I hve to fill ?

[Elie Sbat]

It worked

[Tomonori Taniguchi]

If you enable the media encryption policy, media will go through VCS and call will treat as traversal call as well.

This will work even camera-studios device registered on VCS-C as SIP UA (media encryption policy works for SIP call).

For more information about media encryption policy, please take a look page 6-11 of https://supportforums.cisco.com/docs/DOC-26316 and X7.2 administrator guide.